Changing Finger for rings
- littlelambsy
- Reactions:
- Posts: 4155
- Joined: October 9th, 2012, 6:00 pm
- Location: Vancouver Island, BC
Changing Finger for rings
Does anyone know how change the finger for a ring. I have one made for the middle finger and I'd like it to be worn on the ring finger. Can it be done in s3pe?
- igazor
- Organizer
- Reactions:
- Posts: 17149
- Joined: April 8th, 2013, 6:00 pm
- Location: Everyone should strive to find their inner platypus.
You might find it simpler to keep the ring where it is and swap their fingers around.
Okay, that might look strange. But seriously, I'm pretty sure that would require redesigning the accessory using more tools than S3PE alone -- Milkshape comes into the picture here somewhere? If no one here with the required skill set has a proper answer, this might be a better question for the content creation section of MTS.
Okay, that might look strange. But seriously, I'm pretty sure that would require redesigning the accessory using more tools than S3PE alone -- Milkshape comes into the picture here somewhere? If no one here with the required skill set has a proper answer, this might be a better question for the content creation section of MTS.
- littlelambsy
- Reactions:
- Posts: 4155
- Joined: October 9th, 2012, 6:00 pm
- Location: Vancouver Island, BC
- littlelambsy
- Reactions:
- Posts: 4155
- Joined: October 9th, 2012, 6:00 pm
- Location: Vancouver Island, BC